SOMMER RDC vision - Page 14

14
2.4 Declaration of installation
Declaration of Conformity
forinstallationofanincompletemachineinaccordancewiththeMachineryDirective2006/42/EC,AnnexII,Part1A
SOMMER Antriebs- und Funktechnik GmbH
Hans-Böckler-Straße21-27
73230 Kirchheim/Teck
Germany
hereby declares that the roller door control unit
RDC vision
has been developed, designed and manufactured in conformity with the
• MachineryDirective2006/42/EC
• Low Voltage Directive 2014/35/EU
• Electromagnetic Compatibility Directive 2014/30/EU
• RoHSDirective2011/65/EU
The following standards were applied:
• ENISO13849-1,PL"D"Cat.2
Safetyofmachines-safety-relatedpartsofcontrols-Part1:Generaldesign
guidelines
• EN60335-1,whereapplicable
Safety of electrical appliances / operators for doors
• EN61000-6-3
Electromagneticcompatibility(EMC)-interference
• EN61000-6-2
Electromagneticcompatibility(EMC)-interferenceresistance
ThefollowingrequirementsofAnnex1oftheMachineryDirective2006/42/ECaremet:
1.1.2,1.1.3,1.1.5,1.2.1,1.2.2,1.2.3,1.2.4,1.2.6,1.3.2,1.3.4,1.3.7,1.5.1,1.5.4,1.5.6,1.5.14,1.6.1,1.6.2,1.6.3,
1.7.1, 1.7.3, 1.7.4
ThespecialtechnicaldocumentshavebeenpreparedinaccordancewithAnnexVIIPartBandwillbesubmitted
electronically to the regulators on request.
The incomplete machine is intended for installation in a door system only to form a complete machine as defined by
theMachineryDirective2006/42/EC.Thedoorsystemmayonlybeputintooperationafterithasbeenestablished
that the complete system complies with the EC Directives listed above.
The undersigned is responsible for compilation of the technical documents.
Kirchheim,20-04-2016
i.V.
Jochen Lude
Responsible for documents