SOMMER RDC vision - Safety Instructions; Intended Use of RDC Vision; General Safety Guidelines

4
1. Safety
1.1 Intended use
The roller door control unit RDC vision may only be used:
• to control motors in roller doors (max. motor output: 1000 W).
• according to the instructions and safety information provided in this Installation and
Operating Manual.
Any other use is considered improper use. The manufacturer is not liable for damage
resulting from improper use.
The roller door control unit RDC vision (hereafter referred to simply as "control unit")
may not be used in conjunction with motors in roller grille doors.
1.2 Symbols used
All safety instructions are accompanied by signal words.
These signal words indicate the level of danger and / or severity of injury and /
or property damage that may be incurred in the event of failure to comply with
the instructions and / or safety information.
• Danger indicates an imminent danger causing serious or fatal injury.
• Caution indicates a potentially dangerous situation causing minor injury
or property damage.
For information and useful tips.
1.3 General safety instructions
Personsoperatingorworkingonthecontrolunitmusthaverstreadandunderstood
this Installation and Operating Manual and must comply with all instructions and safety
information provided therein.
All work on the control unit, such as installation, connection and commissioning,
mustbecarriedoutbyatrainedspecialist(qualiedelectrician).
Always keep the Installation and Operating Manual within easy reach.
Always ensure compliance with accident prevention regulations and current standards
in each respective country.
Observe and comply with the "ASR A1.7 Technical Regulations for Workplaces" of
the German Committee for Workplaces (ASTA), which is mandatory for the operator
in Germany.