SOMMER RDC vision - Page 3

3
6.8 Connectingtheanti-dropdevice 31
6.9 Connectingsafetycontactstrips 32
6.10 Connectingothercommanddevices 33
6.11 TorMinal 33
7. Functions 34
7.1 Operatorresponsewhenusingapre-endpositionswitch 34
7.2 Setting the early warning time (red potentiometer) 34
7.3 Setting the automatic closing function 35
7.4 Hold to run mode via radio control system 37
7.5 Buttons and LEDs 37
8. Radio receiver 42
8.1 Deleting the radio receiver memory 42
8.2 ProgrammingthebuttonsofthehandheldtransmitterforOpen-Stop-Close 43
8.3 Programmingthehandheldtransmitterbuttontopulsemode 43
8.4 Deleting individual handheld transmitter buttons 44
8.5 Deleting all handheld transmitter buttons 44
8.6 Settingpartialopening 45
8.7 Switchingthelightingon/offbyradio 46
9. Operation/use 47
9.1 Operation using the button pad in the housing cover 47
9.2 Operationwithexternal3-waybutton 48
9.3 OperationwithexternalPulsebutton 48
9.4 Operation using handheld transmitter 49
9.5 Operation using other command devices 49
10. Maintenance and care 50
10.1 Reading out the number of cycles via the LEDs 50
10.2 Regular inspection 52
10.3 Changing the bulb 52
11. Disassembly 53
12. Troubleshooting 54
12.1 Meaning of blink codes 57
13. Terminal strips 59
13.1 Terminal strip 1: mains power connection and 230 V outputs 59
13.2 Terminalstrip2:signalinputs 60
13.3 Terminalstrip3:safetyinputs 61