SOMMER RDC vision - Page 2

2
1. Safety 4
1.1 Intended use 4
1.2 Symbols used 4
1.3 General safety instructions 4
1.4 Targetgroupsandqualications 6
Brief instructions 7
2. Device overview 11
2.1 Scope of delivery 13
2.2 Technical data 13
2.3 Storage 13
2.4 Declaration of installation 14
3. Installation 15
3.1 Installing the housing 15
3.2 Connectingthecontrolunit 16
3.3 Fitting the housing cover 18
4. Commissioning 19
4.1 Activating dead man mode / hold to run mode 19
4.2 Checking the running direction of the motor 20
4.3 Setting the motor limit switches 20
4.4 Setting the run time (run time monitoring) 21
4.5 Deleting the radio receiver memory 21
4.6 Programmingthehandheldtransmitterbuttontopulsemode 22
4.7 Closing the housing cover 22
5. DIP switches 23
5.1 Warning light response while the door is moving 23
5.2 Operator response to detected obstacle 24
5.3 Automatic closing after opening via pulse input 25
5.4 Partialopeningfunction 25
5.5 Monitoring of motor run time 25
6. Connections 26
6.1 Connectingthewarninglightandthelighting 26
6.2 Connecting2-and3-waybuttons 27
6.3 ConnectingthePulsebutton 28
6.4 Connectingthepre-endpositionswitch 28
6.5 Connectingthebuzzer 29
6.6 Connectingphotocell 30
6.7 ConnectingtheemergencySTOPswitch 31
Table of contents