SOMMER RDC vision - Programming Transmitter Buttons

43
8.2 Programming the buttons of the handheld transmitter for Open-Stop-
Close
1. PressandholddowntheRadiobutton(2)foraround0.5seconds.
Ö The radio LED (3) and the status LED (4) light up.
Programmingmodeenabled.
2. Select the function that you want to be performed when this handheld
transmitter button is pressed in future.
Brieypressthedesiredbuttoninthehousingcover.
Ö ThestatusLED(4)ashesonceintermittently.
3. Pressthedesiredbutton(1)onthehandheldtransmitter.
Ö The radio LED (3) goes out.
Ö The function is assigned to the button you pressed.
4. Repeat steps 1 to 4 for the other buttons on the handheld transmitter and other
functions.
If no radio signal is sent within 10 seconds of the start of programming mode,
programming mode is terminated; the radio LED (3) goes out.
8.3 Programming the handheld transmitter button to pulse mode
1. PressandholddowntheRadiobutton(2)foraround0.5seconds.
Ö TheradioLED(3)andthestatusLED(4)lightup.Programmingmodeenabled.
2. Pressthedesiredbuttononthehandheldtransmitter.
Ö The radio LED (3) goes out.
Ö ThisbuttononthehandheldtransmitterisprogrammedasthePulsebutton.
If no radio signal is sent within 10 seconds of the start of programming mode,
programming mode is terminated; the radio LED (3) goes out.