SOMMER RDC vision - Radio Receiver and Operation

42
8. Radio receiver
Each button on the handheld transmitter has a permanently stored radio code (factory
setting). When you program a button into the radio receiver, the button’s radio code is
transferred to the receiver, where it is assigned a command.
For security reasons, you should completely wipe the memory of the radio
receiver:
beforeprogramminghandheldtransmittersforthersttimeand
• If a handheld transmitter is lost.
• The programmed commands are retained in the event of a power failure.
STAUS
SAFETY
RADIO
START
RADIO
12345678
DIP
ON
ON
ON
SAFETY
RADIO
RADIO
2
3
1
4
8.1 Deleting the radio receiver memory
1. PressandholdtheRadiobutton(2)for20seconds.
Ö TheradioLED(3)initiallylightsupsteadily,then,after5seconds,ashes
once intermittently, lights up again after 10 seconds and then goes out after
20 seconds.
Ö The entire memory of the radio receiver has been wiped.