SOMMER RDC vision - Setting Partial Opening

45
8.6 Setting partial opening
In certain cases, you might want to open the closed door only part of the way, e.g. to put
away a bicycle. The "partial opening" function can be set for this purpose.
1. Close the door.
2. SetDIPswitch6to"ON."
3. PressandholddowntheRadiobutton(2)foraround0.5seconds.
Ö The radio LED (3) lights up.
4. Select the "Open" function.
Ö ThestatusLED(4)ashesonceintermittently.
5. Select the "Open" function again.
Ö The status LED (4) lights up.
6. Pressthedesiredbuttononthehandheldtransmitter.
Ö The radio LED (3) goes out.
7. Using the same button on the handheld transmitter, open the door as far as you
want it to go, stop it and then close it.
Ö The pressed button is programmed for the "partial opening" function.
8. WithDIP6=OFF,youcandeleteaprogrammedpartialopeningtimeatany
point.YoucanthenprogramanewpartialopeningpositionwithDIP6=ON.