SOMMER RDC vision - Page 46

46
8.7 Switching the lighting on / off by radio
1. PressandholddowntheRadiobutton(2)foraround0.5seconds.
Ö The radio LED (3) and the status LED (4) light up.
Programmingmodeenabled.
2. PressandholddowntheStartbutton(9)foraround0.5seconds.
Ö ThestatusLED(4)ashes.
3. Pressthedesiredbuttononthehandheldtransmitter.
Ö The radio LED (3) goes out.
Ö The button of the handheld transmitter for switching the lighting on / off has been
programmed.
This function is not available:
• if motor run times have not been programmed.
• during a door movement.