1
LS10SUB & LS12SUB
IN-GROUND SUBWOOFERS
INSTRUCTION MANUAL
Introduction
Thank you for purchasing SLS Speakers. When properly installed,
these speakers will provide you with years of outdoor entertainment
pleasure. To get the most out of your new speakers, please read this
manual thoroughly before you begin installation.
Box Contents
SLS In-Ground Subwoofer boxes contain:
(1) In-Ground Subwoofer
(1) Dark Brown canopy with ABS tube
(1) Rubber Elbow
(2) Stainless steel hose clamps
(2) Silicon Filled Wire Nuts
Subwoofer Location Selection
The SLS is designed to deliver a seamless, evenly dispersed sound
eld in an ‘open air’ environment. An array of multiple Satellite
speakers and Subwoofers should be strategically placed to
minimize ‘hot spots’ and ‘nulls’ as you move around the outdoor
entertainment area
As a general guideline, (1) Subwoofer will cover about
2000 square feet of listening area
Figure 1 Shows The SLS placed along the perimeter of the
entertainment area.
Select a central location for the subwoofer if using only one subwoofer
(see gure 1) if using multiple subwoofers, select locations that are
the same distance from the main listening area.
4.0" (102mm)
17.625" (448mm)
4.8" (122mm)
16.00" (406mm)
12.40" (315mm)
9.50" (241mm)
Figure 1
Amplier Power Planning
The maximum number of satellites and subwoofers that can be
used in a system will depend on the amplier power available.
Before beginning an installation use the chart below to calculate
the amplier power your installation will require. Multiple
ampliers may be required in large installations.
In-ground Subwoofer
Subwoofer
model qty. ch1 qty. ch2 x watts total ch1 total ch2
LS47SAT x 25
LS67SAT x 25
LS10SUB x 100
LS12SUB x 100
total
20%
head
room
TOTAL MINIMUM WATTAGE
Wattage Calculator
Amplier Selection
For systems up to 500w per channel use the CROWN CDI 1000
For systems up to 800w per channel use the CROWN CDI 2000
For systems up to 1000w per channel use the CROWN CDI 4000
To Next Page
Need help?
General
