Why does my Soniclean 80TD Ultrasonic Jewelry Cleaner stop while operating?
The unit may stop operating due to a thermal cutout. To resolve this: 1. Allow the unit to cool down by unplugging it or switching it off at the wall. 2. If the bath water is hot, empty it out. 3. Wait for at least half an hour before switching the unit on again. 4. If the unit still does not work, contact your supplier or SONICLEAN.
What to do if Soniclean Ultrasonic Jewelry Cleaner has poor foil test result?
If your Soniclean Ultrasonic Jewelry Cleaner shows a poor foil test result, consider the following: 1. Ensure the power level is set to High. 2. Check if the unit has the recommended amount of Soniclean-approved detergent. 3. Confirm the unit has degassed properly; there should be no suspended bubbles in the water during degas mode. 4. If the water is too hot, remove some and replace it with cold water, then replenish the detergent. 5. Verify the aluminum foil thickness is 0.025mm. 6. Replace dirty water with fresh water and degas again, noting that water quality can vary. 7. Remove trays and instruments/parts during the foil test.
General| Brand | Soniclean |
|---|---|
| Model | 80TD |
| Category | Ultrasonic Jewelry Cleaner |
| Language | English |
To Next Page