SonicWALL NSa 3700 - User Manual

1 Package Contents
NOTE: The included power cord is approved for use only in specific countries or regions.
Before using a power cord, verify that it is rated and approved for use in your location. The
power cord is for AC mains installation only. Refer to the NSa 3700 Safety, Regulatory, and
Legal Information document for additional safety information.
メモ: 添付の電源コードに関して電気安全を確保するために、弊社製品にご使用い
ただく電源コードは必ず製品同梱の電源コードをご使用ください。この電源コー
ドは他の製品では使用できません。
Items missing? Contact SonicWall Technical Support at:
https://www.sonicwall.com/support/contact-support
NSa 3700 appliance
Ethernet cable
Serial console cable (RJ45 to DB9)
Power cord (1)
SonicWall NSa 3700 Quick Start Guide
Safety, Environmental, and Regulatory Information documents
2 Front Panel
MGMT
MGMT Port - RJ45: Dedicated 1GE interface for appliance
management and SafeMode access.
Solid Green = Link at speeds 1G or lower, Blinking Green = Activity
console
Console Port - RJ45: Serial Console for CLI access
X28 -
X33
10/5/2.5/1GE SFP/SFP+ Ports and LEDs:
Solid Amber = Link at 10, 5 or 2.5G, Blinking Amber = Activity at 10,
5 or 2.5G, Solid Green = Link at 1G or lower, Blinking Green =
Activity at 1G or lower, Off = No link
X24 -
X27
5/2.5/1GE SFP/SFP+ Ports and LEDs:
Solid Amber = Link at 5 or 2.5G, Blinking Amber = Activity at 5 or
2.5G, Solid Green = Link at 1G or lower, Blinking Green = Activity at
1G or lower, Off = No link
X0 –
X23
RJ45 1GE Copper Ports and LEDs:
Solid Green = Link at 1G or lower, Blinking Green = Activity at 1G or
lower, Off = No link
Amber LED is not used.
SafeMode Button: A recessed button used to enter SafeMode:
If NSa is up: Press button with a narrow, straight object.
If NSa is down: Press while connecting NSa to power and hold until
Test LED blinks yellow three times.
Power Button:
Short press powers ON if the button was used to power the system
off.
Short press powers OFF with Graceful Shutdown. Test and Alarm
LEDs turn Red. Standby power to some circuitry stays on.
Long Press (5+ sec) = Forced Shutdown. Standby power to some
circuitry stays on.
SS
USB SS 3.0 Ports: For Configuration, Recovery, Reimaging the NSa,
and USB WWAN device support.
Storage LED: Solid Green = M.2 extended storage module present,
Blinking Green = Activity, Yellow = Storage warning, Off = No storage
3 Rear Panel
Alarm LED: Red = High Level Alarm (such as Fan Failure) / Power
down requested, Yellow = Lower Level Alarm
Test LED: Red = Power down requested, Yellow = Initializing,
Blinking Yellow = SafeMode / FIPS test in progress, Off = Normal
Power LED: 1 = Primary, 2 = Redundant
Blue = Powered on, Yellow = Defective redundant power supply
System Fans (2)
Redundant Power Input (with cover plate):
A redundant power supply can be ordered separately.
Primary Power Input
4 Connect and Power On
To power on your NSa and connect the LAN and WAN:
1 Connect the provided power cord to the appliance and
to an electrical outlet (100-240 volts). The NSa powers
on. The startup sequence takes about eight minutes.
2Connect the NSa LAN interface (X0 by default) to your
local, internal network.
3Connect the NSa WAN interface (X1) to the Internet.
SonicWall
®
NSa 3700
Quick Start Guide
For product information, use the QR code or go to
SonicWall Tech Docs for NSa
Regulatory Model Number Product Name
1RK52-110 NSa 3700
Copyright © 2023 SonicWall Inc. All rights reserved.
SonicWall is a trademark or registered trademark of SonicWall Inc. and/or its affiliates in
the U.S.A. and/or other countries. All other trademarks and registered trademarks are
property of their respective owners.
The information in this document is provided in connection with SonicWall Inc. and/or its
affiliates' products. No license, express or implied, by estoppel or otherwise, to any
intellectual property right is granted by this document or in connection with the sale of
SonicWall products. EXCEPT AS SET FORTH IN THE TERMS AND CONDITIONS AS SPECIFIED
IN THE LICENSE AGREEMENT FOR THIS PRODUCT, SONICWALL AND/OR ITS AFFILIATES
ASSUME NO LIABILITY WHATSOEVER AND DISCLAIMS ANY EXPRESS, IMPLIED OR
STATUTORY WARRANTY RELATING TO ITS PRODUCTS INCLUDING, BUT NOT LIMITED TO,
THE IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE,
OR NON- INFRINGEMENT. IN NO EVENT SHALL SONICWALL AND/OR ITS AFFILIATES BE
LIABLE FOR ANY DIRECT, INDIRECT, CONSEQUENTIAL, PUNITIVE, SPECIAL OR INCIDENTAL
DAMAGES (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF PROFITS,
BUSINESS INTERRUPTION OR LOSS OF INFORMATION) ARISING OUT OF THE USE OR
INABILITY TO USE THIS DOCUMENT, EVEN IF SONICWALL AND/OR ITS AFFILIATES HAVE
BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SonicWall and/or its affiliates
make no representations or warranties with respect to the accuracy or completeness of
the contents of this document and reserves the right to make changes to specifications
and product descriptions at any time without notice. SonicWall Inc. and/or its affiliates do
not make any commitment to update the information contained in this document.
For more information, visit https://www.sonicwall.com/legal/.
To access the Support Portal, go to https://www.sonicwall.com/support.
SonicWall NSa 3700 Quick Start Guide
Updated - February 2023
232-005579-52 Rev A
Legend
WARNING: A WARNING icon indicates a potential for property damage,
personal injury, or death.
CAUTION: A CAUTION icon indicates potential damage to hardware or loss of
data if instructions are not followed.
IMPORTANT, NOTE, TIP, MOBILE, or VIDEO: An information icon indicates
supporting information.

Summary

Package Contents

NSa 3700 Appliance

The SonicWall NSa 3700 network security appliance.

Ethernet Cable

Standard Ethernet cable for network connectivity.

Serial Console Cable

RJ45 to DB9 serial console cable for CLI access.

Power Cord

Power cord for connecting the appliance to an electrical outlet.

Quick Start Guide

The primary document for initial setup and operation.

Safety and Regulatory Information

Documents detailing safety, environmental, and regulatory compliance.

Front Panel Components

Network Ports and Indicators

Details of MGMT, Console, SFP/SFP+, and RJ45 ports with associated LEDs.

Control Buttons and Ports

Information on the SafeMode button, Power button, and USB 3.0 ports.

Status LEDs

Explanation of Alarm, Test, and Power LEDs for system status.

Rear Panel Components

System Fans

Location and function of the appliance's internal system fans.

Power Inputs

Details on primary and redundant power input connections.

Connect and Power On

Powering On and Network Connection

Steps to connect power, boot the NSa, and link to LAN/WAN.

Setup Options

Local Management Setup

Guide to setting up and managing the NSa via a local computer.

Cloud Management Setup

Instructions for managing the NSa using SonicWall Capture Security Center.

SonicExpress App Setup

Using the SonicExpress app on a smartphone for registration and configuration.

Initial Setup and Registration

Local Management Configuration

Steps for initial configuration using local management interface.

Cloud Management

Accessing and Registering via CSC

Steps to log into CSC, register NSa, and enable Zero Touch/NSM licensing.

SonicExpress App Usage

App Registration and Configuration

Download, launch, and use SonicExpress for NSa setup and registration.

SonicWall Secure SD-Branch

Related Products Overview

Introduction to SD-Branch solutions and related SonicWall products.

SonicWALL NSa 3700 Specifications

General

Maximum Connections	1, 000, 000
High Availability	Yes
Rackmount	Yes
Concurrent Connections	1, 000, 000
New Connections per Second	50, 000
Connections Per Second	50, 000
Power Supply	Dual Redundant
Management	Web UI, CLI