1.Keep off moving objects including such as curtains, greenery, fans and pets during
installation to avoid the device
’
s misjudgment that there are persons nearby.
2.Non-metallic materials including such as glass, plastic, ceramics and plank can be
pierced through.
3.Multiple sensors should be installed in the same direction or back-to-back, avoiding
front-to-front irradiation, and each sensor should be more than 1.5 meter away from
others.
FCC compliance statement
1.This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
2.Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Cautions
FCC Warning
To Next Page
Loading...
Need help?
General
