Sonoff ZigBee Bridge User Manual

Device Pairing Instruction
Switch the Device into Pairing Mode
After powering on, the device will automatically enter the “Quick Pairing Mode” (Touch) during the first use.
The LED indicator of the device will blink like this:
If the LED indicator blinks in other ways, please press the paring button for 5 seconds to switch the device into
“Quick Pairing Mode” (Touch)
Note:
1. Press the button once, the device will quit the pairing mode.
2. If the device is not paired,it will quit pairing mode after 3minutes.
Add the Device in eWeLink
1. Launch eWeLink APP in the mobile phone.
2. Click ”+” icon at the middle bottom of interface.
3. Select “Quick Pairing” for adding device.

Sonoff ZigBee Bridge Specifications

General

Wireless Standard	ZigBee 3.0
Wi-Fi Standard	IEEE 802.11 b/g/n 2.4GHz
Material	PC V0
Weight	35g
Input	5V
Operating Temperature	0°C to 40°C
Compatibility	Zigbee 3.0
Dimensions	62mm x 62mm x 20mm
Operating Current	100-500mA

Summary

Device Pairing Mode

Activate Quick Pairing Mode

Guide on switching the device into its default quick pairing mode, including manual activation via button press.

Pairing Mode Behavior Notes

Information on how the device exits pairing mode automatically or by button press.

Add Device via eWeLink App

Start Device Addition

Steps to launch the eWeLink app and initiate the device pairing process by selecting 'Quick Pairing'.

Configure WiFi Connection

Instructions for selecting a WiFi network, entering the password, and waiting for the device to be found by the app.

Pairing Requirements and Tips

Essential notes for successful pairing, covering WiFi compatibility, password entry, and signal strength.