Sonos ZoneBridge Setup Guide
17
• Be sure that your cable/DSL modem is connected to the router’s WAN (Internet)
port.
• Temporarily remove any other components that are wired to your network.
• Connect an Ethernet cable from the computer directly to the back of the
ZoneBridge, and then connect another Ethernet cable from the ZoneBridge
directly to one of the LAN ports on your router.
• When you make a change to your network configuration, you may need to
power cycle the ZoneBridge by unplugging the power cord, and then plugging
it back in.
• If you are not using a router, visit our Web site at http://faq.sonos.com/norouter
for more information.
If you are still experiencing problems, please contact the Sonos Customer Service
Center.
To Next Page
Loading...
