Sonos ZonePlayer ZP100 - System Requirements for Operation

Sonos ZonePlayer ZP100 Setup Guide
4
1-2-3 Setup
Connect Speakers and Apply Power
• Use your thumb or finger to firmly push the spring-loaded speaker connector post in-
ward to reveal the connection hole.
• Insert the stripped end of the speaker wire into the hole, then release. Repeat for the oth-
er speaker connections.
• Attach the power cable and plug in your ZonePlayer.
Note: Be sure to connect the red ( + ) and black ( - ) terminals from each speaker to
the corresponding terminals on the ZonePlayer. Mismatching of polarities will result
in weak central sound, and a distorted sense of sound direction.
Caution: Make sure the voltage switch is set to the proper position for your
household before plugging in your ZonePlayer ZP100.
Proceed to step 2 when the ZonePlayer Status
indicator on the ZonePlayer’s front panel flashes
white and the Mute button flashes green.
1
Speakers: Power
rating should be at
least 75W for 8 Ohm
speakers and at least
150W for 4 Ohm
speakers.
Voltage
Switch
Make sure the
voltage switch is
set to the proper
position (230 V is
the European
default setting)
Mute button (green)
ZonePlayer
Status Indicator
(white)