Sonos ZonePlayer ZP100 Setup Guide
5
Connect First ZonePlayer ZP100
Connect a standard Ethernet cable (supplied) from any of the four (4) Ethernet switch connectors
on the back of your ZonePlayer to an open port on your router (see A in the diagram below). Do
not connect the ZonePlayer directly to your cable or DSL modem unless your modem has a built-
in router.
• If you don’t have a router, go to http://faq.sonos.com/norouter for instructions.
• If you don’t have an open port on your router, you can disconnect your computer from
the router and connect it to the ZonePlayer instead. Then connect the ZonePlayer into
the router port the computer was previously plugged into.
Note: The first ZonePlayer you install must connect to your home network using a
standard Ethernet cable (supplied). If your computer only has a wireless connection,
you can go to http://faq.sonos.com/wireless for assistance.
2
If you have
structured (built-in)
wiring, connect the
Ethernet cable into a
live wall plate (see B
in the diagram).
To Next Page
Loading...
