Sony Ericsson HCB-30 - Page 7

N
o
t
for
C
o
m
m
e
r
c
i
a
l
U
s
e
Preparing the car handsfree 7
To turn the car handsfree off
• Turn the ignition key to off.
The car handsfree is automatically turned off one hour
after the ignition is turned off. This way, an ongoing
call is not interrupted when the ignition is turned off.
The backlight of the control panel switches off. The car
handsfree is off.
• You can also turn the car handsfree off by pressing and
holding until you hear a short high tone followed
by a short low tone.
Pairing the car handsfree
Before you can use your car handsfree, you must pair it
with your mobile phone. You pair the car handsfree
with the phone by adding the car handsfree to a list of
paired devices in the phone. They then recognize each
other when they connect.
To pair the car handsfree with a Sony Ericsson or
Ericsson phone
1. Turn on the car handsfree.
2. If the indicator light is green or red, the car handsfree
is connected to a Bluetooth device. To disconnect
the devices, press until you hear a tone.
The indicator light is turned off.
3. Press and hold and at the same time until
you hear a long high tone and the indicator lights on
the control panel flash green and red.
4. In the phone, scroll to Extras or Connect,
YES,
Bluetooth,
YES, Paired devices, YES, Add device, YES,
Phone initiates,
YES.
5. A list of device types that you can pair with your phone
appears. Scroll to Headset or Handsfree and press
YES.
6. HCB-30 appears in the display. Press
YES.
7. Enter the car handsfree passkey (0000) and press
YES.
The phone pairing procedure starts.
8. You may now replace the given car handsfree name
with a name of your choice and then press
YES.
When pairing has been completed, the indicator light
on top of the control panel stops flashing.
To pair the car handsfree (general instructions)
1. Turn on the car handsfree.
2. Prepare your phone according to the phone’s user
documentation on pairing.
3. If the indicator light is green or red, the car handsfree
is connected to a Bluetooth device. To disconnect
the devices, press until you hear a tone.
The indicator light is turned off.