EN
8
- When using the camera with
[Auto Power OFF Temp.] set to
[High]
Notes on using memory cards
If (overheating warning icon) is
displayed on the monitor, do not
remove the memory card from the
camera right away. Instead, wait for
a while after turning off the camera,
and then remove the memory card. If
you touch the memory card while it is
hot, you may drop it and the memory
card may be damaged. Be careful
when removing the memory card.
Sony lenses/accessories
Using this unit with products from
other manufacturers may affect its
performance, leading to accidents or
malfunction.
The power cord (mains lead), if
supplied, is designed specifically
for use with this equipment only,
and should not be used with other
electrical equipment.
Note on the 5GHz band for
wireless LAN
When using the wireless LAN function
outdoors, set the band to 2.4GHz
by following the procedure below.
(WW459276 only)
• MENU (Network) [Wi-Fi]
[Wi-Fi Frequency Band]
How to turn off wireless network
functions (Wi-Fi, etc.) temporarily
When you board an airplane,
etc., you can turn off all wireless
network functions temporarily using
[Airplane Mode].
CAUTION
For safety, do not connect the
connector for peripheral device wiring
that might have excessive voltage to
LAN terminal. Follow the instructions
for LAN terminal.
Power Cord
Multiple power cords may be
supplied with this equipment. Use the
appropriate one that matches your
country/region.
For the customers in the UK, Ireland,
Malta and Cyprus
Use the power cord (A).
For safety reasons, the power cord (B)
is not intended for above countries/
regions and shall therefore not be
used there.
For the customers in other EU
countries/regions and Israel
Use the power cord (B).
For safety reasons, the power cord (A)
is not intended for above countries/
regions and shall therefore not be
used there.
(A)
(B)
LAN cable
Use a Category 5e or higher Shielded
Twisted Pair (STP) cable with high
shielding performance.
To Next Page
Loading...
