WARNING
• This device complies with Part
15
of the
FCC
Rules, Operation
is
subject
to
the following two conditions:
(1
)this device may not cause harmful
interference, and (2)this device must accept any interference received,
including interference that may cause undesired operation,
•
You
are cautioned that any changes or modifications not expressly
approved
in
this manual could void your authority
to
operate this
equipment.
Before
use
Before using the
AC
adaptor, please read this manual thoroughly and
retain it for future reference. See also the manuals provided with the
Reader.
How
to
use
1 Connect the
AC
adaptor to the DC
IN
jack of the Reader.
2 Connect to an
AC
outlet using the
AC
power cord.
The indicator on the Reader lights
up
in
red while charging, and
goes
off when
charging
is completed.
This AC
adaptor
can
be
used with either the PRS-500 or PRS-505.
(The
above
figure uses PRS-505 as an example.)
When using this AC adaptor,
charging
time is:
-
PRS-SOS:
Approximate 2
hours'
-
PRS-SOO:
Approximate 4
hours'
• Time required to fully
charge
battery
mmI
•
Do
not use
an
AC
power adapter other than this one with the Reader,
• Connect the
AC
adaptor
to
an
easily accessible
AC
outlet. Should
you
notice
an
abnormality
in
the
AC
adaptor, disconnect
it
from the
AC
outlet.
Specifications
Input
100 - 240 V AC,
SO/60
Hz, 0.26 A
Output
S.2 V DC, 2000
mA
Operating
temperature
41'F
to 9S'F (S'C to 3S'C)
(temperature gradient less than
18'F
(1
O'C)/hour)
Dimensions
Approx. 2.7 x 1.9 x 1.0 inches (w/h/d)
(Approx. 68.3 x 49.5 x
2S.S
mm)
Mass
Approx. S.7 oz. (163
g)
Cord
length
Approx. 70.9 inches (1.8 m)
Supplied
accessories
AC power cord (1)
User's Guide (1)
Design and specifications are
subject
to
change
without notice.
Notes
on
use
•
Do
not place the unit
in
locations that
are:
- Extremely hot or cold
- Dusty or dirty
- Very humid
- Vibrating
- Strong magnetic fields
- Sandy
- Exposed
to
direct sunlight
•
Do
not apply mechanical shock or drop the unit.
• Disconnect the power cord from the
AC
outlet when not
in
use for a long
time.
To
disconnect the power cord, pull
it
out by the plug. Never pull the
cord itself.
•
Be
sure that nothing metallic comes into contact with the metal parts of
this unit.
If
this happens, a short circuit may occur and the unit may be
damaged.
•
Do
not operate the unit with a damaged cord
or
if
the unit itself has been
dropped or damaged.
• Always keep the metal contacts clean.
•
Do
not disassemble or convert the unit.
• While the unit
is
in
use,
it
gets warm, This
is
normal.
• Keep the unit away
from
TV
or
AM
receivers,
as
it
may disturb reception.
On
cleaning
Clean the unit with a soft dry cloth, or a soft cloth lightly moistened with a
mild detergent solution.
Do
not use any type of solvent, such
as
alcohol
or
benzine, which may damage the finish.
If
you
have
any
questions
about
this
product:
Visit:
www.sony.com/readersupport
Contact:
Sony Portable Reader System Support Center at 1-(866)-962-7669
Write:
Sony Customer Information Services Center
12451
Gateway Blvd., Fort
Myers,
FL
33913
To Next Page
Need help?
General
