17
Holder (table sensor 400)
S tight, screw
(PTTWH 3
×
6)
Swing
Table (400) assembly
At this position,this
part will be locked.
Sensor Adjustment
1. Enter the adjustment mode and select “Mech Adjust” with the
JOG dial, and press the dial.
2. Press the GROUP 1 button to operate the loading mechanism,
and continue pressing until the disc table locks. (Fig-3)
3. Loosen the fixing screw and move the holder so that both PLAY
button LED (green) and the ARTIST MODE button LED
(green) light.
If the holder is not in the correct position, the MEGA
CONTROL button LED (orange) or the PAUSE button LED
(orange) lights.
4. Moving the disc table right and left with a hand after the screw
is fixed, the table will move by the play of a disc table. If the
LEDs light up alternately, the adjustment will be performed
correctly. (Fig-4)
FIg-3
FIg-4
MEGA CONTRO
ARTIST MODE
To Next Page
Loading...
