22
Adjusting the listening
position
You can fine-tune the listening position
setting.
1 During reception/playback, press
, rotate the control dial until
“SOUND” appears, then press it.
2 Rotate the control dial until
“POSITION” appears, then press it.
3 Rotate the control dial until “ADJ
POSITION” appears, then press it.
4 Rotate the control dial to adjust the
listening position, then press it.
Adjustable range: “+3” – “CENTER” –
“–3.”
5 Press (BACK) to return to the
previous display.
DM+ Advanced
DM+ Advanced improves digitally
compressed sound by restoring high
frequencies lost in the compression process.
1 During playback, press , rotate
the control dial until “SOUND”
appears, then press it.
2 Rotate the control dial until “DM+”
appears, then press it.
3 Rotate the control dial to select “ON,”
then press it.
4 Press (BACK) to return to the
previous display.
Tip
The DM+ setting can be memorized for each
source other than the tuner.
Using rear speakers as
subwoofer — Rear Bass
Enhancer
Rear Bass Enhancer enhances the bass
sound by applying a low pass filter setting
(page 24) to the rear speakers. This function
allows the rear speakers to work as a
subwoofer if one is not connected.
1 During reception/playback, press
, rotate the control dial until
“SOUND” appears, then press it.
2 Rotate the control dial until “RB ENH”
appears, then press it.
3 Rotate the control dial until “RBE
MODE” appears, then press it.
4 Rotate the control dial to select from
“1,” “2” or “3,” then press it.
5 Press (BACK) to return to the
previous display.
Using a subwoofer without a
power amplifier
— Subwoofer Direct
Connection
You can use the subwoofer without a power
amplifier when it is connected to the rear
speaker cord.
Note
Be sure to connect a 4 - 8 ohm subwoofer to
either of the rear speaker cords. Do not connect a
speaker to the other rear speaker cord.
1 During reception/playback, press
, rotate the control dial until
“SOUND” appears, then press it.
2 Rotate the control dial until “SW
DIREC” appears, then press it.
3 Rotate the control dial until “SW
MODE” appears, then press it.
To Next Page
Loading...
