Sony CDX-R5810 - Page 11

11
The following items can be set (follow the page
reference for details):
“
z” indicates the default settings.
SETUP
DSPL
(Display)
P/M (Play Mode)
SOUND
EDIT
*1 When the unit is turned off.
*2 When the unit is turned on.
*3 In such cases, some FM stereo broadcasts may
become monaural while in the stereo reception
mode.
Clock Adjust (page 4)
Beep
To set “on” (z) or “off.”
RM (Rotary Commander)
To change the operative direction of the rotary
commander controls.
–“Normal” (
z): to use the rotary commander in
the factory-set position.
–“Reverse”: when you mount the rotary
commander on the right side of the steering
column.
AUX-A*
1
(AUX Audio)
To turn the AUX source display “on” (
z) or
“off” (page 13).
Clock (Clock Information)
To display the clock and the display items at the
same time.
–“on”: to display at the same time.
–“off” (
z): to not display at the same time.
Dimmer
To change the brightness of the display.
–“Auto” (
z): to dim the display automatically
when you turn lights on.
–“on”: to dim the display.
– “off”: to deactivate the dimmer.
M.Dspl*
2
(Motion Display)
To select the Motion Display mode.
–“SA” (
z): to show moving patterns and
spectrum analyzer.
–“on”: to show moving patterns.
– “off”: to deactivate the Motion Display.
Demo*
1
(Demonstration)
To set “on” (z) or “off” (page 4).
A.Scroll (Auto Scroll)
To scroll long displayed item automatically
when the disc/group/track is changed.
–“on”: to scroll.
–“off” (
z): to not scroll.
Local (Local seek mode)
–“on”: to only tune into stations with stronger
signals.
– “off” (
z): to tune normal reception.
Mono (Monaural mode)
To improve poor FM reception, select monaural
reception mode.
–“on”: to hear stereo broadcasts in monaural.
– “off” (
z): to hear stereo broadcast in stereo.
IF
–“Auto” (z): to narrow automatically the
reception frequency to eliminate noise.
–“Wide”*
3
: to always hear FM stereo
broadcasts in stereo and with full the
frequency signal reception.
EQ7 Tune (page 9)
HPF (High Pass Filter)
To select the front/rear speaker cut-off
frequency: “off” (
z), “78Hz” or “125Hz.”
LPF (Low Pass Filter)
To select the subwoofer cut-off frequency: “off”
(
z), “125Hz” or “78Hz.”
Loudness
To enhance bass and treble at lower volume.
–“on”: to reinforce bass and treble.
– “off” (
z): to not reinforce bass and treble.
AUX Level
To adjust the volume level for each connected
auxiliary equipment (page 13). This setting
negates the need to adjust the volume level
between sources.
Name Edit (page 10)
Name Delete (page 10)
BTM (page 8)