Sony CFD-S07CP - Cabinet Sections

CFD-S07CP
6
1 wire (flat type) (5 core)
(CN801)
6 cabinet (front) section
cabinet (rear) section
3 CN301(4P)
to MAIN board
Install the wires in the ditch surely.
Attention at the time of the assembling.
2 CN310 (3P)
4 six screws
(+BV tapping (B2.6))
5 four screws
(+BV tapping (B2.6))
0 wire (flat type) (6 core)
(CN808)
qa wire (flat type) (16 core)
(CN810)
6 CN317 (5P)
7 CN316 (4P)
9 CN807 (4P)
8 S801 (2P)
2 screw
(+BV tapping (B2.6))
3 six screws
(+BV tapping (B2.6))
4 two screws
(+BV tapping (B2.6))
5 screw
(+BV tapping (B2.6))
1 battery case lid
qs cabinet (upper) section
Note: Follow the disassembly procedure in the numerical order given.
2-1. CABINET (UPPER) SECTION
2-2. CABINET (FRONT) SECTION