Sony CMT-ED1/ED1A - Specifications

33
Tuner section
FM stereo, FM/AM superheterodyne tuner
FM tuner section
Tuning range 87.5 – 108.0 MHz (50 kHz
step)
Aerial FM wire aerial
Aerial terminals 75 ohm unbalanced
Intermediate frequency 10.7 MHz
AM tuner section
Tuning range 531 – 1,602 kHz
(with the tuning interval
set at 9 kHz)
Aerial AM bar aerial, External
aerial terminal
Intermediate frequency 450 kHz
Speakers
Speaker system Full range, active MFB
Speaker units: 10 cm dia., cone type
Rated impedance 4 ohms
Dimensions (w/h/d) Approx. 195 × 205 × 120
mm (7
3
/4 × 8
1
/8 × 4
3
/4
in)
Mass Approx. 1.5 kg (3 lb 7 oz.)
net per speaker
General
Power requirements 230 V AC, 50/60 Hz
Power consumption 60 watts
Dimensions (w/h/d) Approx. 127 × 212 × 184
mm (5 × 8
3
/8 × 7
1
/4 in)
incl. projecting parts and
controls
Mass Approx. 3.6 kg
(7 lb 15 oz)
Supplied accessories AM bar aerial (1)
Remote RM-SED1 (1)
Stabilizer (1)
Batteries (2)
FM wire aerial (1)
Speaker grille net (1)
Speaker mounting
screws(4)
Optional accesories Wall hunging blacket
WHB-ED1
Speaker saran net
SSN-ED1
Stand SU-ED1
Design and specifications are subject to change
without notice.
Specifications
CD player section
System Compact disc and digital
audio system
Laser Semiconductor laser
(λ = 780 nm)
Emission
duration: continuous
Laser output Max. 44.6
µ W*
* This output is the value
measured at a distance of
200 mm from the
objective lens surface on
the Optical Pick-up Block
with 7 mm aperture.
Wavelength 780 – 790 nm
Frequency response 2 Hz – 20 kHz (±0.5 dB)
Signal-to-noise ratio More than 90 dB
Dynamic range More than 90 dB
Tape player section
Recording system 4-track 2-channel stereo
Frequency response 50 – 13,000 Hz (±3 dB),
(DOLBY NR OFF) using a Sony TYPE I
cassette
50 – 14,000 Hz (±3 dB),
using a Sony TYPE II
cassette
Wow and flutter ±0.15% W. Peak (IEC)
0.1% W. RMS (NAB)
±0.2% W. Peak (DIN)
Amplifier section
DIN power output 15 + 15 watts
(6 ohms at 1 kHz, DIN)
Continuous RMS power output
17 + 17 watts
(4 ohms at 1 kHz, 10%
THD)
Music power output: 22 + 22 watts
Inputs
MD IN (phono jacks): sensitivity 450 mV,
impedance 47 kilohms
Outputs
MD OUT (phono jacks): sensitivity 250 mV,
impedance 1 kilohm
PHONES (stereo phone jack):
accepts headphones of 8
ohms or more
SPEAKER: active speaker system, 4
ohms