Step 2 - Copy the firmware update file to the Memory Stick / Memory Stick PRO /
CompactFlash card / Microdrive media and load it to your camera
• Put the (new or formatted) Memory
Stick / Memory Stick PRO media into
the Memory Stick Slot or adapter on
the computer or put the (new or
formatted) CompactFlash card /
Microdrive into PC card slot on the
computer.
• Select the extracted firmware-file,
right-click the file and select [copy]
from the menu
• Open the Memory Stick /
CompactFlash card / Microdrive
media drive
• Paste the copied file into the Memory
Stick / CompactFlash card /
Microdrive media’s root directory (i.e.,
do not copy it into a folder).
• After the copy-process is complete,
take out the Memory Stick / Memory
Stick PRO / CompactFlash card /
Microdrive media, in order to proceed
with the next step below.
Before you proceed: In order to establish a
properly set-up USB connection, please refer
to the instruction-manual of your camera!
• Connect your Cyber-shot camera to
your PC via the originally supplied
USB-cable, as explained in the
instruction-manual.
• Put the (new, or formatted) Memory
Stick / Memory Stick PRO /
CompactFlash card / Microdrive
media into your camera.
• Select the extracted firmware-file,
right-click the file and select [copy]
from the menu
• Open the Memory Stick /
CompactFlash card / Microdrive
media drive
• Paste the copied file to the Memory
Stick / CompactFlash card /
Microdrive media’s root directory (i.e.,
do not copy it into a folder).
• Turn the camera off, and disconnect
the USB-cable.
To Next Page
Loading...
Need help?
General
