Sony Cyber-shot DSC-F828 Firmware Update Manual

4
Step 3 - Install the firmware update file on your camera
Before you proceed: If the power runs out during the update, this can make your Cyber-shot
camera inoperable! Therefore please use the originally supplied AC adapter as power-source.
• Make sure the camera is powered, but switched off
• Insert the Memory Stick / Memory Stick PRO / CompactFlash card / Microdrive media
containing the firmware-file into your camera.
• Turn the camera’s mode-switch to SETUP.
• While pressing the menu button, turn the camera on.
• Although the firmware is already copied onto the Memory Stick / Memory Stick PRO /
CompactFlash card / Microdrive media, you will see the message "No file in this folder" on the
LCD screen. This is normal (so not a failure). Please go ahead with the next step."
• On the camera-screen-menu, select SETUP 2 > VERSION.
• then it will show the CURRENT VERSION of the firmware.

Sony Cyber-shot DSC-F828 Specifications

General

Sensor Type	CCD
Sensor Size	2/3 inch
Resolution	8.0 Megapixels
Image Processor	Real Imaging Processor
Lens Type	Carl Zeiss Vario-Sonnar T*
Optical Zoom	7x
Digital Zoom	2x
Aperture	f/2.0-2.8
Shutter Speed	30 - 1/3200 sec
LCD Screen Size	1.8 inch
LCD Screen Resolution	134, 000 pixels
Viewfinder	Electronic
Focal Length	7.1-51mm
ISO Sensitivity	64, 100, 200, 400, 800
Storage Media	CompactFlash Type I/II, Memory Stick
Battery Type	NP-FM50 InfoLithium
Dimensions	134 x 91 x 156 mm
Weight	906 g (including battery and memory card)