Sony CyberShot DSC-P72 - User Manual

http://servis-manual.com/

Summary

SECTION 6 ADJUSTMENTS

1. Before starting adjustment

Procedures for EVR data rewriting before calibration.

1-1. Adjusting items when replacing main parts and boards.

Adjusting items when replacing main parts

Lists adjustments needed based on replaced components.

6-1. ADJUSTMENT

1-1. PREPARATIONS BEFORE ADJUSTMENT

Lists service tools and setup required for adjustments.

1-1-2. Preparations

General setup steps before performing adjustments.

1-1-3. Discharging of the flashlight power supply

Safety procedure to discharge high voltage.

4. Preparing the Flash Adjustment Box

Instructions for building a dark box for strobe adjustment.

1-2. INITIALIZATION OF 0 E, 2 F, 4 F, 6 F PAGE DATA

1-2-1. INITIALIZATION OF 2 F PAGE DATA

Procedure to initialize specific camera data.

1-2-2. Initializing the 4 F Page Data

Procedure to initialize specific camera data.

1-2-3. Initializing the 6 F Page Data

Procedure to initialize specific camera data.

1-2-4. INITIALIZATION OF 0 E PAGE DATA

Procedure to initialize specific camera data.

1-3. VIDEO SYSTEM ADJUSTMENTS

1. Video Output Level Adjustment (SY-85 board)

Calibrates the composite video signal output level.

1-4. CAMERA SYSTEM ADJUSTMENTS

1. Data Setting during Camera System Adjustments

2. Flange Back Adjustment (Using Minipattern Box)

8. Auto White Balance Adjustments

CCD Adjustments

17. Strobe Adjustment

1-5. LCD SYSTEM ADJUSTMENT

LCD Initial Data Input

VCO Adjustment (SY-85 board)

VG Center Adjustment (SY-85 board)

Bright Adjustment (SY-85 board)

White Balance Adjustment (SY-85 board)

1-6. SYSTEM CONTROL SYSTEM ADJUSTMENT

1. Battery End Check (SY-85 board)

6-2. SERVICE MODE

2-1. APPLICATION FOR ADJUSTMENT (SEUS)

2-2. Bit value discrimination

Switch and LED Checks

Sony CyberShot DSC-P72 Specifications