28
Presetting radio stations
4 Press . or > repeatedly to select
the preset number you want to store the
station on while the preset number
flashes.
5 Press TUNE + or – to tune in the station
you want while the preset number
flashes.
6 Press DISPLAY/MENU.
When the station is preset successfully,
the beep sounds. The new station replaces
the old one.
The preset number increases by one and
the CD player enters the preset memory
standby mode.
7 Repeat steps 4 to 6 when you preset the
stations in the same band. When you
preset the stations in the different band,
press and hold MEMORY to exit the
preset memory standby mode. Repeat
steps 2 to 6 after the preset number stops
flashing.
To exit the preset memory standby
mode
When the radio is turned on, you can exit the
preset memory standby mode using one of
the following procedures. Preset stations,
however, will remain stored in the CD
player’s memory.
• Hold down MEMORY until the preset
number stops flashing.
• Do not press any button for 30 seconds.
The preset number stops flashing.
• Press u. The CD player enters the CD
playing mode.
• Press x•RADIO OFF. The radio turns off.
To cancel all preset stations
1 While the radio is turned off and CD play
is stopped, press and hold DISPLAY/
MENU until the MENU screen appears.
2 Press V or v to select “OPTION,” then
press u/ENTER.
3 Press V or v to select “TUNER
PRESET,” then press u/ENTER to enter
the selection.
“Clear?” appears in the display. When you
press u/ENTER, all the preset stations
are canceled.
Playing preset radio
stations
You can tune in the station easily by pressing
. or > button.
1
Press RADIO ON/BAND to select
the band.
2
Press . or > to tune in a
stored station.
To Next Page
Loading...
