48
US
Getting Started
Note
• When you use both the TV (AUDIO IN) jacks
(analog connection) and TV (COAXIAL or
OPTICAL DIGITAL IN) jack (digital
connection) at the same time, the digital
connection takes priority.
2 Press SYSTEM MENU.
3 Press X/x repeatedly until “DEC.
MODE” appears in the front panel
display, then press or c.
4 Press X/x repeatedly until the
decoding mode you want appears in
the front panel display.
When you want to output the TV sound or
stereo sound of a 2 channel source from the
six speakers, select the “PRO LOGIC,”
“PLII MOVIE,” or “PLII MUSIC”
decoding mode.
For details, see page 49.
5 Press .
The setting is made.
6 Press SYSTEM MENU.
The system menu turns off.
Note
• Depending on your TV, you may need to turn off your
TV’s speaker to enjoy surround sound of the system.
Ti
• When listening to audio files using a portable audio
source, you can enhance the sound.
Press FUNCTION +/– to select “AUDIO.” Connect
the portable audio source. Select “A.F.D. STD” for
“DEC. MODE” and set the sound mode (page 51) to
“MOVIE,” “MUSIC,” or “NEWS.”
To cancel, select other than “A.F.D. STD.”
Distortion may occur when you listen to a
component connected to the TV, SAT/CABLE
jacks on the rear panel, or to the AUDIO IN jack
on the front panel. Distortion is not a
malfunction and will depend on the component
connected.
To prevent distortion, reduce the input level on
the unit.
1 Press FUNCTION +/– repeatedly until
“TV,” “SAT/CABLE,” or “AUDIO”
appears in the front panel display.
2 Press SYSTEM MENU.
3 Press X/x repeatedly until
“ATTENUATE” appears in the front
panel display, then press or c.
4 Press X/x to select a setting.
• “ATT ON”: You can attenuate the input
level. The output level is changed.
• “ATT OFF”: Normal input level.
5 Press .
The setting is made.
6 Press SYSTEM MENU.
The system menu turns off.
Changing the input level of the
sound from connected
components
To Next Page
Loading...
Need help?
General
