Sony DAV-SC8 - Step 3: TV and Video Component Hookups; Connecting to a TV

18
GB
Required cords
SCART (EURO AV) cord for connecting a TV (not supplied)
Audio/video cords (not supplied)
When connecting a cord, be sure to match the colour-coded sleeves to the appropriate jacks on the
components.
Terminals for connecting video components
Connecting the system to a TV
Connect the system to your TV using the SCART (EURO AV) cord. Be sure to connect the SCART
(EURO AV) cord to the T EURO AV OUTPUT (TO TV) jack on the system.
When you connect using the SCART (EURO AV) cord, check that the TV conforms to S video or RGB
signals. If the TV conforms to S video, change the input mode of the TV to RGB signals. Refer to the
operating instructions supplied with the TV to be connected.
Note
When you use the VIDEO 1 line outputs, please set the system to 2CH STEREO mode. If the system is not in 2CH
STEREO mode, the line outputs may not function properly.
Step 3: TV and Video Component Hookups
Connect the To the
TV T EURO AV OUTPUT (TO TV) jack
VCR VIDEO 1 jacks
Digital satellite receiver VIDEO 2 jacks
Yellow (Video)
White (L/audio)
Red (R/audio)