Help Guide
Digital Still Camera
DSC-RX100M6
Using flash
In dark environments, use the flash to light up the subject while shooting. Also use the flash to prevent camera-shake.
When you do not use the flash
When not using the flash, press it back into the camera body.
Note
If you fire the flash before the flash unit pops up entirely, it may cause malfunction.
You cannot use the flash when recording movies.
When shooting with the flash and the zoom is set to W, the shadow of the lens may appear on the screen, depending on the
shooting conditions. If this happens, shoot away from the subject or set the zoom to T and shoot with the flash again.
When the monitor is tilted upward 90 degrees or more, it is difficult to operate the
(Flash pop-up) switch. Raise the flash unit
before adjusting the monitor angle.
When using flash to shoot pictures of yourself, be careful not to look directly at the light, because the flash will go off at a close
distance. To prevent the flash from hitting the monitor when you press it back down into the camera body after use, first return the
monitor to its original position.
Slide the (Flash pop-up) switch to pop up the flash.
The flash does not pop up automatically.
1
Press the shutter button fully down.
The available flash modes depend on the shooting mode and function.
2
To Next Page
Loading...
