DSLR-A230 4-140-593-11(1)
Quick Start Guide
DSLR-A230
Preparation Shooting Playback
The battery pack
1 Charge the battery pack until the
CHARGE lamp lights off.
For customers in the U.S.A. and Canada
CHARGE lamp
For customers in countries/regions
other than the U.S.A. and Canada
CHARGE lamp
Power cord (mains lead)
2 Insert the battery pack into the camera.
Firmly insert the battery pack all the
way while pressing the lock lever with
the tip of the battery.
The lens
1 Remove the body cap on the camera
and packaging lid on the rear of the
lens.
Do not touch inside parts.
If dust enters the camera, it may
appear on the photo image. Do not
leave the camera and lens without
the caps. When you change the lens,
do it quickly in a location free from
dust.
2 Mount the lens by aligning the index
marks as illustrated.
Turn the lens until it clicks.
Remove the lens cap during
shooting.
The memory card
1 Open the memory card cover.
2 Insert a memory card and select the
type of the memory card you want to
use using the memory card switch.
Terminal part
Face side (SD memory card)
Face side (“Memory Stick PRO
Duo”)
Terminal part
When inserting a memory card, turn the
camera off.
For available memory cards, refer to the
Instruction Manual.
Date/time setup
1 Turn the camera on.
2 Set up the date/time.
1 Set the mode dial to AUTO.
2 Look into the viewfinder.
Adjust the diopter-adjustment dial if the
focus of the viewfinder is not achieved.
Hold the grip of the
camera.
Support the lens from
below.
3 Press the shutter button
halfway down to focus.
Pressing the shutter button halfway
down and holding it activates the
autofocus.
4 Press the shutter button fully
down to shoot.
Press .
To play back a previous or next image: press /
on the control button.
To return to the shooting mode:
To delete the image
Press .
To fully enjoy the features of your single lens reflex
camera, consult the “Instruction Manual.”
Control button
Need help?
General
