Sony DSX-A42UI - Listening to the Radio; Radio Tuning and Storage

8GB
To match the volume level of the
connected device to other sources
Start playback of the portable audio device
at a moderate volume, and set your usual
listening volume on the unit.
Press SELECT, and rotate the control dial to
select [AUX VOL] (page 14).
Listening to the Radio
To listen to the radio, press SOURCE to select
[TUNER].
1 Press MODE to change the band.
2 Press and hold SELECT (FM1, FM2,
FM3, MW or LW).
The setup display appears.
3 Rotate the control dial to select
[BTM], then press it.
The unit stores stations in order of
frequency on the number buttons.
1 Press MODE to change the band
(FM1, FM2, FM3, MW or LW).
2 Perform tuning.
To tune manually
Press and hold SEEK +/– to locate the
approximate frequency, then press SEEK
+/– repeatedly to fine adjust to the
desired frequency.
To tune automatically
Press SEEK +/–.
Scanning stops when the unit receives a
station. Repeat this procedure until the
desired station is received.
Listening to the Radio
Storing automatically (BTM)
Tuning