Sony DSX-A60BT - Pairing and connecting with a BLUETOOTH device

9GB
When connecting a BLUETOOTH device
(cellular phone, audio device, etc.) for the
first time, mutual registration (called
“pairing”) is required. Pairing enables this
unit and other devices to recognize each
other.
1 Place the BLUETOOTH device within
1 m (3 ft) of this unit.
2 Press CALL, rotate the control dial to
select [PAIRING], then press it.
flashes.
The unit enters pairing standby mode.
3 Perform pairing on the BLUETOOTH
device so it detects this unit.
4 Select [Sony Automotive] shown in
the display of the BLUETOOTH
device.
If [Sony Automotive] does not appear,
repeat from step 2.
5 If passkey* input is required on the
BLUETOOTH device, input [0000].
* Passkey may be called “passcode,” “PIN
code,” “PIN number” or “Password,” etc.,
depending on the device.
When pairing is made, stays lit.
6 Select this unit on the BLUETOOTH
device to establish the BLUETOOTH
connection.
or lights up when the connection is
made.
Note
While connecting to a BLUETOOTH device, this unit
cannot be detected from another device. To enable
detection, enter the pairing mode and search for
this unit from another device.
To cancel pairing
Perform step 2 to cancel the pairing mode
after this unit and the BLUETOOTH device are
paired.
To use a paired device, connection with this
unit is required. Some paired devices will
connect automatically.
1 Press CALL, rotate the control dial to
select [BT SIGNL], then press it.
Pairing and connecting with a
BLUETOOTH device
Connecting with a paired
BLUETOOTH device
[0000]
Input passkey