EasyManua.ls Logo

Sony Handycam CCD-TRV21E - Identifying the Parts (Continued); Remote Control Operation and Range; Demonstration Mode

Sony Handycam CCD-TRV21E
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
• Remote ¢ommander_',-_:TTi!; : q i_'Teie_m-anclo i::_:;::-_ 7_:::
Po
o)
Using the Remote Commander
Make sure that the COMMANDER mode is set to
oN (p.37).
The buttons that have the same name on the
Remote Commander as on the camcorder
function identically.
Utilizacidn del telemando
Cerci6rese de activar (Oh. r) el modo de telemando
(COMMANDER) (p_g. 37).
Las teclasque poseen elmismo hombre en el
telemando y en lavideoGimara funcionar_ndecb
forma iddntica.
[]
[]
[]
[]
[]
[] Transmitter
Point toward the remote sensor to control the
camcorder after turning on the camcorder.
[] Tape transport buttons (p.22)
[] R6 (size AA) battery holder (p.67)
[] START/STOP button
Power zoom button
The zooming speed is unchangeable on the
Remote Commander.
[] Transmlsor
Apunte con _1haciaelsensorremoto para
controlarlavideoGimaradespuds de haber
conectado]aalimentaci6nde lamisma.
[] Teclas de transporte de la cinta (p_g. 22)
Compartimiento de las pilas R6 (tamarSo
AA) (pdg. 67)
,_ Tecla de inicio/parada (START/STOP)
Tecla del zoom motorizado
La veJocldad de] zoom no podr_ cambiarse
en el telemando.
To prepare the remote commender
To use the Remote Commander, you must insert
two R6 (sizeAA) batteries.Use the suppliedR6
(sizeAA) batteries,
(I)Remove thebatterycoverfrom the Remote
Commander.
(2) Insert both of the R6 (size AA) batteries with
correct polarity.
(3) Put the battery cover back onto the Remote
Commander.
Preparacidn del telemando
Para utilizar el te_emando, deberA colocar dos
pilas R6 (tarna_o AA). Utilice las pflas R6
(tama_o AA) suminlstradas.
(1) Quite la tapa del comparfimiento de las pilas
en el telemando.
(2) Inserte las dos pilas R6 (tamaflo AA) con la
polaridad correcta.
(3) Cierre ]a tapa.
1
Note on battery life
The batteries for the Remote Commander last
about 6 months under normal operation. When
the bafferJes become weak or dead, the Remote
Commander does not work.
3
Nota sobre la duraci6n de las pJlas
Lasl_i]aseneltelemando durar:Inunos 6 meses
en condic/onesnormalesde funcionamiento.
Cuando laspi]assedebi]iteno agoten,el
te]emandono funcionar_.
To avoid damage from possible battery
leakage
Remove the batteries when you will not use the
Remote Commander for a long time.
Para evitar el dar_o que podria causar el
derrame del electrolito de las pilas
Cuando no vaya a utilizar el telemando durante
mucho tiempo, extraiga ]as pilas.
m
_r
66 67