107
Connecting your camcorder to a TV and a VCR
Dubbing a disc to a tape
Dubbing to a tape
Before operation
•Set [DISPLAY] in (OTHERS) to [LCD] in
the SETUP display (the default setting is
[LCD]).
•Press the following buttons to make the
indicators disappear so that they will not be
superimposed on the edited tape:
– DISPLAY/BATT INFO
– DISPLAY on the Remote Commander
– DATA CODE on the Remote Commander
1 Insert the recorded disc into your
camcorder.
2 Prepare the VCR for recording.
Insert a blank tape (or a tape you want
to record over) into the VCR.
Set the input selector to LINE.
Refer to the operating instructions of the
VCR.
3 Start recording on the VCR.
4 Play back the recorded disc on your
camcorder.
When you have finished dubbing
Stop recording on the VCR, then press x on
your camcorder.
To Next Page
General
