Sony HT-CT150 - Setting the speaker level (CNT LEVEL, SW LEVEL); Adjusting the bass and treble level (BASS, TREBLE); Adjusting the delay between the sound and the image (A;V SYNC)

• These settings are retained even if you disconnect the
AC power cord (mains lead).
The following pages show details for each
setting.
Setting the speaker level (CNT
LEVEL, SW LEVEL)
You can adjust the level and the balance of the
center speaker and subwoofer.
1 Select "LEVEL" in the AMP menu, then
press (-,-_ or
->.
Z Select "CNT LEVEL" or "SW LEVEL,"
then
press _ or
->.
• CNT LEVEL: Adjusts the center speaker
level.
• SW LEVEL: Adjusts the subwooter
level.
3
Select the parameter you want and
press (_).
The parameter of"CNT LEVEL" and "SW
LEVEL" is fiom "_6" to "+6" in l-step
increments. The default setting is "0."
Enjoying Dolby Digital sound
at low volume (AUDIO DRC)
Narrows the dynamic range of the sound track.
Usetid for enjoying movies at low volume.
AUDIO DRC only applies to Dolby Digital
sources.
1 Select "LEVEL" in the AMP menu, then
press (_ or +.
2 Select "AUDIO DRC," then press (_ or
->.
3 Select the setting and press (_.
• OFF: No compression of dynanfic range.
• STD: Reproduces the sound track with
the kind of dynanfic range that the
recording engineer intended.
• MAX: Compresses dynanfic range lidly.
Adjusting the bass and treble
level (BASS, TREBLE)
You can adjust the bass and treble level easily.
1 Select "TONE" in the AMP menu, then
press (_ or +.
2 Select "BASS" or "TREBLE," then
press @ or +.
• BASS : Adjusts the bass level.
• TREBLE :Adjusts the treble level.
3 Select the parameter you want and
press (_.
The parameter is fiom "_6" to "+6" in l-step
increments. The default setting is "0."
Adjusting the delay between
the sound and the image (A/V
SYNC)
You can delay the sound using this timction
when the image is slower than the sound.
1 Select"AUDIO" in the AMP menu, then
press (_ or +.
2 Select "A/V SYNC," then press (_) or +.
3 Select the setting and press @.
• OFF: No adjustnlent.
• ON: Adjusts the difference between
picture and sound.
• You may not be able to adjust the delay between
sound and image perfectly using this fimction.
• This function is useful only for Dolby Digital, DTS
and Linear PCM (2ch) input via digital coaxial cord,
digital optical cord or HDMI cable.
30 GB