Connecting
the
FM
wire
antenna
(aerial)
Connect the FM wire antenna (aerial) to the FM 75 n COAXIAL jack.
~
FM
75
n
COAXIAL
jack
"
FM
wire
antenna
(aerial)
(supplied)
o
.er
Rear
of
the
-------------...
subwoofer
• Be sure to fully extend the FM wire antenna (aerial).
• After connecting the FM wire antenna (aerial), keep
it
as horizontal as possible.
• Do not use the FM wire antenna (aerial) while it
is
bundled up.
• Insert the FM wire antenna (aerial) fully and firmly to the terminal.
• If you have poor FM reception, use a 75-ohrn coaxial cable (not supplied) to connect the subwoofer to an outdoor
FM antenna (aerial) as shown below.
Rear
of
the
subwoofer
Outdoor
FM
antenna
(aerial)
Connecting
the
AC
power
cord
(mains
lead)
Before connecting the AC power cord (mains lead)
of
the system to a wall outlet (mains), connect all
the other components and TV to the system.
I:ll!.UD
• After connecting the AC power cord (mains lead), wait about 20 seconds before turning on the power by pressing
1/(9.
• Connect the system to an easily accessible AC outlet (mains). Should you notice
an
abnormality in the system,
disconnect the main plug from the AC outlet (mains) immediately.
Setting
up
the
sound
output
of
the
connected
component
To enjoy sound in multi-channel format (DTS, Dolby Digital, multi-channel LPCM), you need to make
the audio output settings
of
the connected component. Set the connected component to output sound in
multi-channel format. For details on audio output settings, refer to the operating instructions supplied
with the connected component.
27
US
To Next Page
