Enjoying
multiplex
broadcast
sound
(DUAL
MONO)
Setting
the
sound
from
the
satellite
tuner
(INPUT
MODE)
Changing
the
brightness
of
the
front
panel
display
(DIMMER)
Select "OPT" and press
8.
• AUTO: Preferentially output the sound
signal from the
HDMI
SAT/
CA
TV
input jack.
• OPT:
Output
the signal from the
SAT/
CATV
OPT
IN jack.
Select "AUDIO"
in
the AMP menu, then
press 8
or~.
2 Select "INPUT MODE," then press G)
or~.
3
Even
if
you
connect
the satellite tuner to the
HDMI SAT/CA
TV
input
jack
of
the system,
multi-channel sound may not be output
depending on the satellite tuner.
In
this case.
connect a digital optical cord
to
the SAT/CA
TV
OPT
IN
jack
of
the system in addition to
an
HDMI
cable, and
make
the following setting.
1
You can enjoy multiplex broadcast sound when
the system receives an AC-3 multiplex broadcast
signal.
•
To
receive an AC-3 signal, you need to connect a
digital satellite tuner to the system with an optical
cable
or
coaxial cable, and set the digital output mode
of
the digital satellite tuner to AC-3.
1 Select "AUDIO"
in
the AMP menu, then
press 8
or~.
2 Select "DUAL MONO," then press 8
or
~.
3 Select the setting and press
8.
• MAIN: Plays back only the main
channel.
• SUB: Plays back only the sub
channel.
•
MAIN/SUB:
Main sound is output from
the left speaker and sub
sound is output from the
right speaker.
Enjoying
the
sound
at
low
volume
(NIGHT
MODE)
You can enjoy sound effects and hear the dialog
clearly
even
at a low volume level using this
function.
1 Select "AUDIO"
in
the AMP menu, then
press
8
or~.
2 Select "NIGHT MODE," then press 8
or~.
3 Select the setting and press
8.
•
ON:
Turns
on
the
"NIGHT
MODE"
function.
• OFF: Turns
off
the function.
The
brightness
of
the front panel display can be
set to
one
of
2 levels.
1 Select "SYSTEM"
in
the AMP menu,
then press
8 or
~.
2 Select "DIMMER," then press 8
or~.
3 Select the setting and press
8.
• ON: Dim.
• OFF: Bright.
• You can listen to Dolby Digital sound
at
low volume
by using
AUDIO
DRC
(page 49).
50
US
To Next Page
