• These settings are retained even
if
you disconnect the
AC power cord (mains lead).
The following pages show details for each
setting.
Setting
the
speaker
level
(CNT
LEVEL, SW
LEVEL)
You can adjust the level and the balance
of
the
center speaker and subwoofer.
1 Select "LEVEL" in the AMP menu, then
press
8)
or
~.
2 Select "CNT LEVEL"
or
"SW LEVEL,"
then press
8 or
~.
• CNT LEVEL: Adjusts the center speaker
level.
• SW LEVEL: Adjusts the subwoofer
level.
3 Select the parameter you want and
press
(8.
The parameter
of
"CNT
LEVEL" and
"SW
LEVEL" is from
"-6"
to
"+6"
in I-step
increments. The default setting
is
"0."
Enjoying Dolby
Digital
sound
at
low
volume
(AUDIO
DRC)
Narrows the dynamic range
of
the sound track.
Useful for enjoying movies at low volume.
AUDIO DRC only applies to Dolby Digital
sources.
1 Select "LEVEL" in the AMP menu, then
press
8)
or
~.
2 Select "AUDIO DRC," then press
8:)
or
~.
3 Select the setting and press
8:).
• OFF: No compression
of
dynamic range.
• STD: Reproduces the sound track with
the kind
of
dynamic range that the
recording engineer intended.
• MAX: Compresses dynamic range fully.
Adjusting
the
bass
and
treble
level
(BASS,
TREBLE)
You can adjust the bass and treble level easily.
1 Select "TONE" in the AMP menu, then
press
8:)
or
~.
2 Select "BASS"
or
"TREBLE," then
press
8)
or
~.
•
BASS:
Adjusts the bass level.
•
TREBLE:
Adjusts the treble level.
3 Select the parameter you want and
press
8:).
Theparameteris from
"-6"
to "+6" in I-step
increments. The default setting
is
"0."
Adjusting
the
delay
between
the
sound
and
the
image
(AN
SYNC)
You can delay the sound using this function
when the image
is
slower than the sound.
1 Select "AUDIO" in the AMP menu, then
press
8:)
or
~.
2 Select
"AN
SYNC," then press
8:)
or~.
3 Select the setting and press 8).
• OFF: No adjustment.
• ON: Adjusts the difference between
picture and sound.
• You may not be able to adjust the delay between
sound and image perfectly using this function.
• This function is useful only for Dolby Digital, DTS
and Linear PCM (2ch) input via digital coaxial cord,
digital optical cord or HDMI cable.
conunued--------
49
US
To Next Page
