Sony HT-RT4 - Settings and Adjustments; Using the Setup Display; Menu Options Explained

18
GB
Using the setup display
You can set the following items with the menu.
Your settings are retained even if you disconnect the AC power cord (mains lead).
1 Press MENU to turn on the menu in the front panel display.
2 Press BACK/ / /ENTER repeatedly to select the item and press ENTER to
select the setting you want.
3 Press MENU to turn off the menu.
The default settings are underlined. They may differ depending on the area.
Settings and Adjustments
Menu list
Menu items Function
“LVL >”
(Level)
“SUR.L”/“SUR.R”
(Surround left/right
speaker level)
“0.0”
: Adjusts the sound level of the Surround Speakers
from –6.0 dB to +6.0 dB (0.5 dB interval).
Be sure to set “TTONE” to “ON” for easy adjustment.
“ATT”
(Attenuation
settings – Analog)
Distortion may occur when you listen to a device
connected to the ANALOG IN jack. You can prevent
distortion by attenuating the input level on the system.
“ON”: Attenuates the input level. The output level will
decrease at this setting.
“OFF”: Normal input level.
“DRC”
(Dynamic range
control)
Useful for enjoying movies at low sound volume. DRC
applies to Dolby Digital sources.
“ON”: Compresses sound according to the information in
the content.
“OFF”: Sound is not compressed.
“TTONE”
(Test tone)
“ON”: The test tone is output from each speaker in
sequence.
“OFF”: Turns off the test tone.
“SPK >”
(Speaker)
“PLACE”
(Speaker
placement)
“STDRD”: Select this setting if you install the Bar Speaker
and the Surround Speakers in standard position.
“FRONT”: Select this setting if you install the Bar Speaker
and the Surround Speakers in front.
“SUR.L”/“SUR.R”
(Surround left/right
speaker distance)
“3.0M”
: Adjusts the distance from the seating position to
the Surround Speakers from 1.0 meter to 6.0 meters.
Note