Sony ICP-3016 - Page 189

USO RESTRITO
Applying Special Effects (Overall Signal Effects) 189
No.
Parameter
Adjustment
3
Soft
Softness
No.
Parameter
Adjustment
1
Luminance
Luminance
2
Saturation
Saturation
3
Hue
Hue
No.
Parameter
Adjustment
1
H
Horizontal position
2
V
Vertical position
3
Size
Size of mask
4
Soft
Softness of mask
5
Pattern
Pattern number
a)
Chapter
10
DME
Operations
4 Press [Matte] and set the glow color.
When turning [Aspect] on and setting the aspect
ratio of the pattern
No.
Parameter
Adjustment
1
Aspect
Aspect ratio
When turning [Angle] on in the <Rotation> group
and slanting the pattern
No.
Parameter
Adjustment
1
Angle
Rotation angle of pattern
a)
To invert the highlight areas
Press [Glow Invert], turning it on.
The highlight and non-highlight areas are inverted.
To mask the Glow effect with a selected pattern
Press [Mask] to display the Mask menu (4127)
( 1 p. 189), and set the pattern type and modifiers.
Mask Settings
Applying masks
1 Open the DME >Video Modify >Mask menu (4127).
2 In the <Mask> group, press the button for the group of
the effect to which you want to apply the mask, turning
it on.
Effect Gp1: Posterization, Solarization, Nega, Sepia,
Mono, Contrast, Mosaic, Sketch, Metal
a) 1 p. 104.
When turning [Speed] on in the <Rotation> group and rotating the pattern at a constant rate
No.
Parameter
Adjustment
1
Speed
Rotation speed of pattern
a)
a) 1 p. 104.
Notes on applying a mask effect with a
DME (only when using the MVE-9000)
In the <Mask> group of the DME >Video Modify >Mask
menu (4127), if [Effect Gp1] and [Effect Gp2] are
simultaneously set to On, then the border or beveled edge
is also masked.
The following explains this with the example of using a
circular mask pattern.
Image 1: Image before applying mask
Effect Gp2: Defocus, Blur, Glow
Notes
On the MKS-6570 and MVE-8000A, [Effect Gp1] and
[Effect Gp2] cannot be turned on at the same time.
3 Press [Position/Size].
4 Set the mask source parameters.
Border or
beveled edge
m
Image 2: State with only [Effect Gp1] set to On
Portion 2 has
“Mono” masked,
and only
“Defocus”
applied.
Image with
“Mono(chrome)”
or “Defocus”
applied
Portion 1 has
both “Mono”
and “Defocus”
applied.
a) Pattern 304 is not supported by the MKS-6570 or MVE-8000A.
5 To invert the black and white of the mask source, press
[Invert], turning it on.
6 As required, set the modifiers for the mask pattern.
m
In the state corresponding to image 2, if you switch [Effect
Gp2] to On, then the mask should be applied to portion 2
only. In fact, however, the border or beveled edge is also
masked.