(B) Guidance bar
Note
If the entire angle of the panoramic shot is not achieved within the set time, a
gray area occurs in the composite image. If this happens, move the product
faster to record the full panoramic image.
When [Wide] is selected for [Panorama: Size], the entire angle of the panoramic
shot may not be achieved within the given time. If this happens, try shooting
after changing [Panorama: Size] to [Standard].
Since several images are stitched together, the stitched part may not be
recorded smoothly in some cases.
The images may be blurred in dark scenes.
When a light source such as a fluorescent light flickers, the brightness and color
of a stitched image may not be consistent.
When the whole angle of panoramic shooting and the AE/AF locked angle are
very different in brightness and focus, the shooting may not be successful. If
this happens, change AE/AF locked angle and shoot again.
The following situations are not suited for shooting Sweep Panorama:
Moving subjects.
Subjects that are too close to the product.
Subjects with continuously similar patterns, such as the sky, beach, or a lawn.
Subjects with constant change such as waves or water falls.
Subjects with brightness widely different from its surroundings such as the sun or a
light bulb.
The Sweep Panorama shooting may be interrupted in the following situations.
When the camera is panned too fast or too slow.
The subject is too blurry.
Hint
To Next Page
Loading...
