Sony KDL-24R400A - Page 6

Chassis: RB1FK, BA
Th
e c
i
rcu
i
t
b
oar
d
s use
d
i
n t
h
ese mo
d
e
l
s
h
ave
b
een processe
d
us
i
ng
Lead Free Solder. The boards are identified by the LF logo located
close to the board designation e.g. H1 etc [ see example ]. The
servicing of these boards requires special precautions to be taken as
outlined below.
example
It is strongly recommended to use Lead Free Solder material in order to guarantee optimal quality of new solder joints.
Lead Free Solder is available under the following part numbers :
Due
to the higher melting point of Lead Free Solder the soldering iron tip temperature needs to be set to 370 degrees celsius.
This
requires soldering equipment capable of accurate temperature control coupled with a good heat recovery characteristics.
rebmuntraP retemaiD skrameR
91-500-046- m7 m3. g0 K52.0
02-500-046- m7 m4. g0 K05.0
12-500-046- m7 m5. g0 K05.0
22-500-046- m7 m6. g0 K52.0
32-500-046- m7 m8. g0 K00.1
42-500-046- m7 m0. g1 K00.1
52-500-046- m7 m2. g1 K00.1
62-500-046- m7 m6. g1 K00.1
Chassis: RB1FK, BA 6