Sony KLV-46V400A - Connecting Antenna, Cable, and VCR

5
GB
Start-up Guide
KLV-46/40/32V400A
3-300-887-11(2)
B For KLV-32V400A
1 Place the TV onto the stand by aligning the
screw hole alignment lines over the stand
as shown.
2 Fix the TV to the stand according to the
arrow marks that guide the screw holes
using the supplied screws.
• This TV is very heavy, so two or more people
should place the TV on the stand.
• If using an electric screwdriver, set the tightening
torque at approximately 1.5N·m (15kgf·cm).
• When installing the TV onto the wall, follow step
1 to prevent the TV panel from falling over.
• Ensure the AC power cord is away from screw
holes during stand installation to avoid damage to
the AC power cord (KLV-32V400A only).
2: Connecting an
antenna/cable/VCR
Connecting an antenna/cable
8
8
8
8
Connecting an antenna/cable and VCR
Antenna cable
(not supplied)
S video
cable
(not
supplied)
Antenna cable
(not supplied)
Antenna cable
(not supplied)
Audio/Video
cable (not
supplied)
VCR