Location and Function of Parts and Controls
9
j Input select buttons
Press the button to monitor the signal input to each
connector.
A-1, A-2, B-1 and B-2 buttons are used when an
optional input adaptor has been installed in the option
slot.
COMPOSITE button: to monitor the signal through
the COMPOSITE IN connector
Y/C button: to monitor the signal through the Y/C IN
connector
RGB button: to monitor the RGB signal through the
connectors for the R/G/B signal input
COMPONENT button: to monitor the component
signal through the connectors for Y/P
B/PR signal input
A-1 button: to monitor the signal from connector 1
(the connectors for the R/G/B signal input in BKM-
229X) of the input adaptor installed to the option slot
A
A-2 button: to monitor the signal from connector 2
(the connectors for Y/P
B/PR signal input in BKM-
229X) of the input adaptor installed to the option slot
A
B-1 button: to monitor the signal from connector 1
(the connectors for the R/G/B signal input in BKM-
229X) of the input adaptor installed to the option slot
B
B-2 button: to monitor the signal from connector 2
(the connectors for Y/P
B/PR signal input in BKM-
229X) of the input adaptor installed to the option slot
B
HD15 button: to monitor the signal through the
HD15 input connector
DVI button: to monitor the signal through the DVI-D
input connector
k Function buttons
You can turn the assigned function on or off.
The factory setting is as follows;
F1 button: EXT SYNC
F2 button: SCAN
F3 button: ASPECT
F4 button: MULTI DISPLAY
You can assign the function from among SCAN,
ASPECT, EXT SYNC, BLUE ONLY, MONO, H/V
DELAY, MULTI DISPLAY and APA in FUNCTION
BUTTON SETTING of the USER CONFIG menu (see
page 26).
For details of the function assigned to the function
button, see page 26.
l MEMORY button
Press to load the picture settings saved in the USER
MEMORY menu (on page 27).
To Next Page
Loading...
Need help?
General
