Sony M-2000 - Page 2

Precautions
To prevent fire or shock hazard, do not expose the unit to rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel
only.
INFORMATION
This equipment generates and uses radio frequency energy and if not installed and used Properly,
that
is,
in
strict
accordance
with
the
manufacturer's
instructions,
may
cause
interference
to
radio
and television reception. It has been type tested and found to comply with the limits for a Class B
computing device in accordance with the specifications in Subpart J of Part 15 of FCC Rules,
which are designed to provide reasonable protection against such interference in a residential
installation. However, there is no guarantee that interference will not occur in a particular installa-
tion.
if
this
equipment
does
cause
interference
to
radio
or
television
reception,
which
can
be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient the receiving antenna
Relocate the equipment with respect to the receiver
Move the equipment away from the receiver
Plug
the
equipment
into
a
different
outlet
so
that
equipment
and
receiver
are
on
differant
branch
circuits.
If necessary, the user should consult the dealer or an experienced radioftelevision technician for
additional
suggestions.
The
user
may
find
the
following
booklet
prepared
by
the
Federal
Commu-
nications Commission helpful:
“How
to
Identify
and
Resolve
Radio-TV
Interference
Problems”.
This
booklet
is
available
from
the
U.S. Government Printing Office, Washington, DC 20402, Stock No. 004-000-00345-4.
* Auto backspace function makes transcribing easy by reviewing the last few recorded words
each time listening is resumed.
+ Adjustable tape speed and tone control.
* Two alarms (End-of-tape, No-cassette) alert you.
*
Use
the
supplied
AC
power
adaptor.
Do
not
use
any
other
AC
power
adaptor
as
it
may
cause
malfunction.
e
The
nameplate
indicating
operating
voltage,
power
consumption,
and
the
caution
labels
are
located
at
the
bottom.
*
Unplug
the
unit
from
the
wall
outlet
when
it
is
not
to
be
used
for
an
extended
period
of
time.
To
disconnect
the
cord,
pull
it out
by
grasping
the
plug.
Never
pull it
by
the
cord.
+ Use only the (mickocasserve)™ with this unit.
* Two lape speeds can
elected for recording with the TAPE SPEED selector: 2.4 cm/sec. or 1.2 cm/sec,
Match the playback speed to the recording speed.
+
Do
not
install
the
unit
in
a
location
near
heat
sources
such
as
radiators
or
airducts,
or
in
a
place
subject
to
direct
sunlight,
excessive
dust,
mechanical
vibration,
or shock.
+
Allow
adequate
air
circulation
to
prevent
internal
heat
build-up.
Do
not
place
the
unit
near
materials
(cur-
tains,
draperies)
that
may
block
the
ventilation
holes.
+
Should
any
solid
object
or
liquid
fall
into
the
unit,
unplug
the
unit
and
have
it
checked
by
qualified
person-
nel
before
operating
it
any
further.
Slack in the tape
Before inserting, take up any slack in the tape
by using a pencil.
Note on the Microcassette
This unit uses only modern standard
Microcassettes. The non-standard Microcas-
settes cannot be-used because their "L?
To
prevent
accidental
erasure
dimension
shown
in
the
illustration
below
is
When a recording is made, the previous different.
recording is automatically erased. To prevent
erasure, break the cassette tabs.
Only the standard
To record on a cassette with removed tabs Microcassette has a
Cover each slot with a piece of plastic tape. Standard small indentation
here.
Ono) Approx. 5 mm
L
Non-standard
To protect
side A
Approx. 25 mm