Need help?Do you have a question about the Sony MDR-EX10LP/LBL and is the answer not in the manual?
General| Type | Closed, Dynamic |
|---|---|
| Driver Unit | 9 mm |
| Sensitivity | 100 dB/mW |
| Cable Length | 1.2 m |
| Weight | 3 g (without cord) |
| Cord | Y-type |
| Impedance | 16 ohm |
| Plug | L-shaped stereo mini plug |
| Frequency Response | 8 Hz - 22, 000 Hz |
Details the driver unit size and type, specifying 9mm dome type (CCAW).
Specifies the audible frequency range the headphones can reproduce, from 8Hz to 22,000Hz.
Indicates the electrical impedance at 1kHz, measured at 16 ohms.
Measures sound pressure level output per milliwatt of input power, at 100 dB/mW.
Describes the physical form factor of the headphones as an earbud style.
Indicates the absence of a headband, typical for earbud designs.
Specifies the type of magnet used, which is Neodymium.
Details the connector type as an L-shaped stereo mini plug.
Classifies the intended use as portable devices.
Describes the cord specifications, including length, material, and type.
Specifies the maximum power the headphones can handle, rated at 100 mW (IEC).
Defines the speaker enclosure type as closed and the driver type as dynamic.
Provides the approximate length of the headphone cord, measuring 47 1/4 inches (1.2 m).
States the approximate weight of the headphones, excluding the cord, at 3 grams.
Lists the included accessories: ear tips in three sizes, instructions, and warranty card.
