23
Customizing the equalizer
curve — EQ3
“CUSTOM” of EQ3 allows you to make
your own equalizer settings.
1 Select a source, then press the select
button.
2 Rotate the control dial until “EQ3
LOW,” “EQ3 MID” or “EQ3 HIGH”
appears, then press it.
3 Rotate the control dial to adjust the
volume level, then press it.
The volume level is adjustable in 1 dB
steps, from –10 dB to +10 dB.
Repeat steps 2 and 3 to adjust the
equalizer curve.
To restore the factory-set equalizer
curve, press and hold the select button
before the setting is complete.
4 Press (BACK).
Adjusting setup items
1 Press and hold the select button.
The setup display appears.
2 Rotate the control dial until the desired
item appears, then press it.
3 Rotate the control dial to select the
setting, then press it.*
The setting is complete.
4 Press (BACK).
* For CLOCK-ADJ and BTM settings, step 4 is
not necessary. And for BT SIGNL and
PAIRING settings, step 3 and 4 are not
necessary.
The following items can be set depending
on the source and setting:
CLOCK-ADJ (Clock Adjust) (page 6)
CT (Clock Time)
Activates the CT function: “ON,” “OFF”
(page 11).
BEEP
Activates the beep sound: “ON,” “OFF.”
CAUT ALM (Caution Alarm)*
1
Activates the caution alarm: “ON,”
“OFF” (page 6).
AUX-A (AUX Audio)*
1
Activates the AUX source display: “ON,”
“OFF” (page 24).
AUTO OFF
Shuts off automatically after a desired
time when the unit is turned off: “NO,”
“30S (Seconds),” “30M (Minutes),” “60M
(Minutes).”
REAR/SUB*
1
Switches the audio output: “REAR-
OUT” (power amplifier), “SUB-OUT”
(subwoofer).
To Next Page
Loading...
Need help?
General
