Sony MHC-1700 - Page 2

To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified
personnel only.
RISK OF ELECTRIC SHOCK
DONGT OFEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK:
DO NOT REMOVE COVER (OR BACK),
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
‘This symbol is intended to alent the user to
the presence of uninsulated “dangerous
voltage” within the product's enclosure
that may be of sufficient magnitude to
constitute a risk of electric shack to
persons,
‘This symbol is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
terature accompanying the appliance.
For the customers in Canada
CAUTION:
‘TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS
POLARIZED AC PLUG WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT
BLADE EXPOSURE.
For the customers in the U.S.A.
Owner’s Record
The model ané serial numbers are located at the rear of the unit,
‘Record these numbers inthe epaces provided below. Refer to
them ikhenever you call upon your Sony dealer regarding this,
product
Mode! No. HOD-H1700 Serial No,
Mode! No, TCH1700 Serial No.
Model No, SS+17006, Serial No.
INFORMATION
This equipment generates and uses radio frequency energy and it
not installed and used properly, that is, in strict accordance with
‘the manufacturer's insteuctions, may cause interference to radio
ane television reception, It has been type tested and found 19
‘comply withthe limits for a Class B computing device in
‘accordance with the specifications in Subpart J of Part 15 of FCC.
ules, which are designed to provide reasonable protection
against such interference in @ residential installation, However,
there fs no guarantee that interference will not occur In a
particular installation, If this equipment does cause interlerence to
radio oF television reception, witich can be determined by turning
‘he equipment off and on, the user is encouraged to try to correct
‘the interference by one or more of the following measures:
Reorient the receiving antenna
Relocate the equipment with respect to the receiver
‘Move the equipment away from the receiver
Plug the equipment into a dlforent outiet so that equipment an
receiver are on ditterent branch cireults.
W necessary, the user should consul the dealer oF an experienced
radioitelevision tochnician for additional suggestions, The user
‘may find the following booklet prepared by the Federal
‘Communications Commission helptul:
“How to Identify and Resolve Radio-TV tnterference Problems’
“This booklet Is available from the U.S. Government Printing Office,
Washington, DC 20402, Stack No. 004-000-00545-4
CAUTION
‘The use of optical instruments with this product will
increase eye hazard.
Laser component in this products capable of emitting
radiation exceeding the limit for Class 1.
This apparatus complies with the Class B limits for radio
noise emissions set out in Radio Interference Regulations.
‘This appliance is classitied as a
GLASS 1 LASER product.
‘The CLASS 1 LASER PRODUCT
Jabel I¢ located on the rear
exterior.
- Note to CATV system installer:
This reminder is provided to call the CATV system installer's
altention to Anicie 820-40 of the NEC that provides guidelines
for proper grounding and, in particular, specifies thal the cable
‘found shall be connected to the grounding system of the
building, 26 close to the point of cable entry as practical